GE PT925SNSS - Profile 30" SC Convection Ovens Owner's Manual page 30

Before you call for service...
Troubleshooting Tips
Problem
"Crackling" or
"popping" sound
Excessive smoking
during a clean cycle
Oven door will not
open after a clean cycle
Oven not clean after
a clean cycle
"LOCKED" flashes
in the display
"LOCKED" is on
when you want
to cook
"F—and a number
or letter" flash
in the display
"LOCKED" appears
in the oven display
Control signals after
entering cooking time
or start time
Display goes blank
Display flashes
Unable to get the
display to show "SF"
"Probe" appears
in the display
30
Possible Causes
This is the sound of the
metal heating and cooling
during both the cooking and
cleaning functions.
Excessive soil.
Oven too hot.
Oven controls not properly set. • See the Using the self-cleaning oven section.
Oven was heavily soiled.
The self-clean cycle has been
selected but the door is not
closed.
The oven door is locked
because the temperature
inside the oven has not
dropped below the
locking temperature.
You have a function error code. • Disconnect all power to the oven for
The controls have
been locked.
You forgot to enter a
bake temperature or
cleaning time.
A fuse in your home may be
blown or the circuit breaker
tripped.
The clock is in the
black-out mode.
Power failure.
Oven control pads were
not touched properly.
This is reminding you to
enter a probe temperature
after plugging in the probe.
What To Do
• This is normal.
• Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until LOCKED goes off.
Wipe up the excess soil and reset the clean cycle.
• Allow the oven to cool below locking temperature.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
• Close the oven door.
• Touch the CLEAR/OFF pad. Allow the oven to cool.
at least 30 seconds and then reconnect power.
If the function error code repeats, call for service.
• See the Control Lock section to unlock.
• Touch the BAKE pad and desired temperature or
the SELF CLEAN HI/LO pad and desired clean time.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BROIL HI/LO and BAKE pads must be touched
at the same time and held for 3 seconds.
• Enter a probe temperature.