To screw the cover plate for the cable feedthrough to the mounting plate, follow the steps
below:
1. Fit the cover plate on the mounting plate from below until the two lugs (position A in the
2. Secure the cover plate to the mounting plate with two M4 screws. The screws are
5.4.3
Fitting the mounting plate to an S7-300 standard rail
Procedure
Figure 5-10
Follow the steps below to fit the mounting plate to an S7-300 standard rail:
1. Place the mounting plate with the two protruding catches on the top edge of the S7-300
2. At the bottom, the mounting plate has two lugs with holes. Screw the lugs to the S7-300
SCALANCE W786 outdoor access point
Operating Instructions, 06/2013, A5E02280428-08
figure above) engage the lower edge of the mounting plate.
supplied with the assembly kit.
Side view of a mounting plate on an S7-300 standard rail
standard rail (position A in the figure above).
standard rail (position B in the figure above). The required screws are supplied with the
mounting plate.
5.4 Mounting with mounting plate
Mounting
29