Table of Contents
Advertisement
Installing
4.5 Mounting the motor
Size KS3 to KS10
1
1505
1555
Figure 4-3
Procedure
1. Loosen the bolt 1 slightly.
2. Fit the coupling half 1556 onto the motor shaft end, as described in Mounting an input or
output element on the gearbox shaft (Page 27).
3. Maintain the clearances z12 and z.
4. Apply adhesive (medium strength, e.g. Loctite 243) to the bolt 1.
5. Tighten bolt 1 with the specified torque T
In the case of 2 bolts, tighten both alternately in equal steps with the specified tightening
torques.
6. Insert the elastomer 1557 in the already assembled coupling half 1556 on the motor shaft
end.
7. Lightly grease or oil the tooth flanks to reduce the mounting force.
8. Apply adhesive (medium strength, e.g. Loctite 243) to the bolts 1505.
9. Fasten the motor using the bolts 1505 with the specified torque based on the table in Thread
sizes and tightening torques for fastening bolts (Page 27).
The claws of the coupling parts must intermesh.
32
Bolt
Bolt
Coupling half
KS adapter
1556
Coupling half
1557
Elastomer
SW.
A
SIMOGEAR adapters for gearboxes - KS, K2, K3, K4, K5, KQ, KQS, K8, A, AZ
Operating Instructions, 05/2022, A5E37431501A/RS-AL
Advertisement
Table of Contents
