Table of Contents
Advertisement
STARTING ENGINE
1. Turn engine switch to "ON".
2. Choke engine if necessary (you may not need to choke a warm engine).
3. Pull starter rope repeatedly until engine starts.
4. If choke was moved to the closed position to start, gradually move it to the open
position as the engine warms up.
5. Allow engine to warm up for one or two minutes.
STOPPING ENGINE
1. Move throttle to idle position.
2. Let engine idle for one or two minutes.
3. Turn switch on engine to "STOP" position.
4. Turn off electric valve
Warning! Always stop the engine before:
1. Cutting electric.
2. Leaving the equipment unattended for any amount of time.
3. Before making any repairs or adjustments to the machine.
Warning! Never run the Screed above idle when the float blade is not in contact
with concrete. This can damage the float blade.
USER SCREED
The Screed can be used with or without forms. The following describes the use of
the Screed without forms.
1.
Use a hand float to make a 300-500mm diameter wet pad (A) at the desired
grade in the four corners of the area you wish to screed. The outer extents of
the wet pads should not exceed the length of the float blade being used.
NOTE: Use a laser receiver, transit level, or grade stakes to help establish the
correct grade.
Tel:(+86)17737606271
6
Henan Master Machinery Co., Ltd
www.mastermachinerys.com
Advertisement
Table of Contents
