Reinstalling The Jack And Tools - Dodge RAM 2500 2022 Owner's Manual

Reinstalling The Retainer
3. Lay the wheel flat after the retainer is installed.
4. Attach the lug wrench to the extension tubes
with the curved angle facing away from the
vehicle. Insert the extensions through the
access hole between the lower tailgate and
the top of the fascia/bumper and into the
winch mechanism tube.
CAUTION!
The winch mechanism is designed for use with
the jack extension tube only. Use of an air
wrench or other power tools is not
recommended and can damage the winch.
Lug Wrench And Extension Tubes Assembled And In
Position
5. Rotate the lug wrench handle clockwise until
the wheel is drawn into place against the
underside of the vehicle. Continue to rotate
until you feel the winch mechanism slip, or
click three or four times. It cannot be
overtightened. Push against the tire several
times to ensure it is firmly in place.
NOTE:
Have the flat tire repaired or replaced immediately.
WARNING!
A loose tire or jack thrown forward in a collision
or hard stop could endanger the occupants of
the vehicle. Always stow the jack parts and the
spare tire in the places provided. Have the
deflated (flat) tire repaired or replaced
immediately.
IN CASE OF EMERGENCY
R T J A
EINSTALLING HE ACK ND
1. Tighten the jack all the way down by turning
the jack turn-screw counterclockwise until the
jack is snug.
2. Position the jack and tools into bracket
assembly. Make sure the lug wrench is under
the jack near the jack turn-screw. Snap tools
into bracket assembly clips. Install the jack
into bracket assembly and turn the jack
turn-screw clockwise until jack is snug into
bracket assembly.
Jack And Tools Bracket Assembly
373
T
OOLS
7