If Engine Fails To Start - Dodge RAM 2500 2022 Owner's Manual

If the vehicle is not in PARK and the driver turns off
the engine, the vehicle may AutoPark.
AutoPark will engage when all of these conditions
are met:
Vehicle is equipped with a rotary shifter and an

8-speed transmission
Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Ignition is switched from ON/RUN to ACC

NOTE:
For Keyless Enter 'n Go™ equipped vehicles, the
engine will turn off and the ignition switch will
change to ACC position. After 30 minutes the
ignition switches to OFF automatically, unless the
driver turns the ignition switch off.
If the vehicle is not in PARK and the driver exits the
vehicle with the engine running, the vehicle may
AutoPark.
AutoPark will engage when all of these conditions
are met:
Vehicle is equipped with a rotary shifter and an

8-speed transmission
Vehicle is not in PARK

Vehicle speed is 1.2 mph (1.9 km/h) or less

Driver's seat belt is unbuckled

Driver's door is ajar

Brake pedal is not pressed

The message "AutoPark Engaged Shift to P then
Shift to Gear" will display in the instrument cluster.
NOTE:
In some cases the ParkSense graphic will be
displayed in the instrument cluster, causing the
"AutoPark Engaged Shift to P then Shift to Gear" to
not be seen. In these cases, the shifter must be
returned to "P" to select desired gear.
If the driver shifts into PARK while moving, the
vehicle may AutoPark.
AutoPark will engage ONLY when vehicle speed is
1.2 mph (1.9 km/h) or less.
The message "Vehicle Speed is Too High to Shift to
P" will be displayed in the instrument cluster if
vehicle speed is above 1.2 mph (1.9 km/h).
WARNING!
If vehicle speed is above 1.2 mph (1.9 km/h),
the transmission will default to NEUTRAL until
the vehicle speed drops below 1.2 mph
(1.9 km/h). A vehicle left in the NEUTRAL
position can roll. As an added precaution, always
apply the parking brake when exiting the vehicle.
STARTING AND OPERATING
4WD Low — If Equipped
AutoPark will be disabled when operating the
vehicle in 4WD Low.
The message "AutoPark Disabled" will be
displayed in the instrument cluster.
Additional customer warnings will be given when
all of these conditions are met:
Vehicle is not in PARK

Driver's door is ajar

Vehicle is in 4WD Low range

The message "AutoPark Not Engaged" will be
displayed in the instrument cluster. A warning
chime will continue until you shift the vehicle into
PARK or the driver's door is closed.
ALWAYS DO A VISUAL CHECK that your vehicle is in
PARK by looking for the "P" in the instrument
cluster display and near the shifter. As an added
precaution, always apply the parking brake when
exiting the vehicle.
I E F T S
F NGINE AILS O TART
If the engine fails to start after you have followed
the "Normal Starting" procedure, it may be
flooded. Push the accelerator pedal all the way to
the floor and hold it there while the engine is
cranking. This should clear any excess fuel in case
the engine is flooded.
133
4