Switching The Display - Clarion DXZ946MP Owner's Manual

Switching the operation mode
There are 2 basic operation modes: standard
operation and simple operation.
1. In the main display screen, touch and hold
the left of the display for 1 second or longer.
The operation mode is switched.
98.10MHz
In the simple operation, the operations of
touching or
CD mode main display screen are not required,
and this unit can be used by performing simple
operation.
Note, however, that the following operations are
not available in the simple operation.
• Preset tuning, folder selection, disc selection,
and other operations that involve touching
on the right of the display
• Display switching operations (cf. page 13)
• Title display switching operations (cf. page 14)
• Operations for displaying title entry screens.
In screens (e.g. list display, adjust mode, etc.)
other than the main display, there is no
difference between the standard operation
and the simple operation.
Descriptions given in this manual are mainly for
the standard operation. For descriptions for
operations in the simple operation, refer to the
descriptions for the screen displays in the radio
mode or the CD mode.
SIMPLE MODE
MODE
B
BAND
in the radio mode or

Switching the display

1. Touch the center of the display.
Each time you touch the display, it changes
as follows:
Title display
98.10MHz
Spectrum Analyzer display
98.10MHz
Time display
1 0 1 0 0 5 0 5
98.10MHz
Screen saver
When the screen saver function is set to "ON",
and you do not operate this unit for about 30
seconds, the screen saver will be displayed. For
details, see page 36.
Basic Operations
USER
MODE
FM1
4 2
3 B
BAND
S/A SCAN
MODE
FM1
4 2
B
3
BAND
MODE
a m a m
FM1
4 2
B
3
BAND
13
DXZ946MP