Switching The Display; Adjusting The Volume - Clarion DXZ788RUSB Owner's Manual

01_DXZ788RUSB_EN.book 14 ページ ２００７年１１月２７日 火曜日 午後６時３４分
Basic Operations
Turning on/off the power
Note:
• Be careful about using this unit for a long time
without running the engine. If you drain the car's
battery too far, you may not be able to start the
engine and this can reduce the service life of the
battery.
1. Press the [SRC] button.
The mode that was previous active is
displayed.
2. Press and hold the [SRC] button for 1
second or longer to turn off the power for the
unit.
Selecting a mode
1. Press the [SRC] button to change the
operation mode.
2. Each time you press the [SRC] button, the
operation mode changes in the following
order:
Radio CD/MP3/WMA/AAC
iPod (TEL) (CD changer)
Radio...
∗ External equipment not connected with
CeNET is not displayed.
∗ iPod /MTP can connect to this unit via USB
cable.

Adjusting the volume

1. Push the [VOL] button upward or downward
to adjust the volume.
∗ The volume level is from 0 (minimum) to 33
(maximum).
14
DXZ788RUSB

Switching the display

1. Each time you press and hold the [TITLE]
button for 1 second or longer, the display
switches in the following order:
Action display
time)
∗ When CT data is not received, "– –:– –CT"
appears in the display.
Mute
Use this function to turn off the sound
immediately.
1. Press the [
The sound turns off and "MUTE" blinks in the
display.
2. Press the [
mute mode.
USB/MTP/
AUX
Title display CT (clock
Action display...
] button.
] button again to cancel the