Table of Contents
Advertisement
1.
Introduction
This CC2431DK User Manual describes how to use the software and hardware included in
the CC2431 Development Kit.
Please refer to the Quick Start Guide for a brief introduction on how to get started using the
development kit.
2.
About this manual
This manual contains some of the theoretical material needed to develop a positioning system
based on CC2431 and gives a brief introduction to the software provided in the kit.
3.
Definitions
Blind Node
Reference Node
GUI
Chipcon Packet Sniffer
Z-location Engine
RSSI
TIMAC
SOC_BB
CC243xEM
CC2430-F128
A node using CC2431 and the Location Engine to calculate its
own position.
A node located on a static location.
Graphic User Interface
A PC tool to visualize traffic on radio
A PC tool used to configure and display location engine results
Received Signal Strength Indicator
Texas Instruments Media Access Control, a SW protocol that
handles IEEE 802.15.4 data handling
System on Chip Battery Board
CC2430/ CC2431 Evaluation Module, a small plug-in module
for SmartRF04DK, should be used as reference design for RF
layout.
CC2430 with 128 kB FLASH
SWRU076D
CC2431
Page 4 of 32
Advertisement
Table of Contents
