Specifications for Signal Personality Characteristics
EDGE/EGPRS
[real-time mode]
[Option 402]
1. Measurements also require Option 300.
Multiframe output data generation
Coding scheme
Data
Frame structure
Adjacent timeslots
Data
Frame structure
1
Multiframe measurements
EDGE measurement modes
Static sensitivity
Sensitivity search
BER/BLER
EDGE measurement results
MCS-1: uplink and downlink, MCS-5: uplink and downlink,
MCS-9: uplink and downlink, E-TCH/F43.2
PN9 or PN15
The selected data sequence is fully coded
continuously across the RLC data blocks according to
MCS-1, MCS-5, MCS-9 or E-TCH/F43.2. An independent
version of the selected data sequence is coded across the
unused RLC/MAC header fields [The CPS header field is
as defined in GSM 04.60 V8.50].
52-frame multi-frame structure for EDGE/EGPRS channel
as per ETSI TS 100 909, 3GPP TS 05.03, V8.9.0, 2000-11
[release 1999]. [Coding is done on frames 0-11, 13-24,
26-37, 39-50 on a 52 PDCH multi-frame. Frame 25 and
51 are idle [RF blanked].]
Coded MCS-1, MCS-5 or MCS-9 with continuous PN9 or
PN15 sequence data payload.
Uncoded PN9, PN15.
Note: Maximum of 4 timeslots can be turned on with
EDGE/EGPRS multi-frame coded data.
EDGE/EGPRS PDCH multi-frame.
Repeating EDGE frame.
BER/BLER at user-specified power level measured;
based on bit errors in total unencoded data, and block
errors in coded channels.
Automatically finds the input level [sensitivity] that causes
user-specified BER [uncoded] or BER [coded].
Erased data block count/rate for coded channel
[MCS-1, MCS-5 or MCS-9].
Total data block count for coded channel
[MCS-1, MCS-5 or MCS-9].
Payload bit error count/rate for raw BER.
Total burst count for raw BER. Data block count which
contains residual bit errors and bit error count.
Downlink error reporting
27