Janome 1200D Manual page 61

To Remove:
1. Remove the back cover.
2. Disconnect the 4 connectors (q, w, e, t).
3. Remove the setscrews C and TB/SW unit from the motor bracket.
Remove the nut A and remove the motor lead r from the TB/SW unit.
4. Remove the nuts (or screws) B and remove the motor from the motor bracket.
Remove the motor pulley from the motor.
To Attach:
5. Replace the motor and attach the motor lead r to the TB/SW unit with the nut A.
6. Attach the TB/SW unit to the motor bracket. Be sure to insert the insulation plate between the TB/SW
unit and motor bracket. (*for 220V motor, attach the condenser cover instead)
7. Attach the new motor to the motor bracket. Connect the 2 connectors e and t to the micro switch of
the safety device. Connect the other connectors q and w to the lamp leads.
8. Adjust the motor belt tension and tighten the nuts (or screws) B.
e
r
A
q
w
120V Motor unit
e
r
A
q
w
220V Motor unit
Replacing the Motor
t e
C
q
w
TB/SW unit
r
Motor pulley
t e
C
q
w
TB/SW unit
r
Motor pulley
B
Insulation plate
r
B
Condenser Cover
r
MODEL 1200D
q
w
e
t
q
w
e
t