Janome 1200D Manual page 22

Hide thumbs Also See for 1200D:

Table of Contents

HEIGHT AND ORIENTATION OF NEEDLE BAR IN RELATION

TO THE NEEDLE PLATE HOLES

1. Remove: Mains lead - Sewing foot.

2. Insert a new needle (No.90) in "R1".

3. With needle bar at its highest position, loosen screws "a" just enough so that

needle bar slides with friction.(Fig.1)

4. Place gauge on needle plate and adjust height of needle bar so that needle "R1"

grazes the gauge.(Fig.2)

5. For the orientation of needle bar or needle holder, insert new needles in "L0 , L1

and L2", orientate needle bar so that the needles are centered in the needle plate

holes. Make sure that neither needle "L0 , L1 nor L2" is touching the inside of the

needle plate holes. Tighten screw "a" and recheck the height.(Fig.3)

6. Remove needle plate and check the clearance between the chain and lower looper

and needle(s). If necessary, adjust clearance of chain looper (see page 11) and

clearnace of lower looper (see page 6).

Table of Contents