Janome 1200D Manual page 10

POSITION OF THE DISPLAY DRUM INDICATOR
1. Remove: Mains lead - Front cover
2. Make sure if tension cams and levers are set in proper positions when selecting
sewing program 1 "SAFETY
3. Select sewing program 10 "COVER HEM/CHAINSTITCH".
4. Bring the needle bar to its lowest position by turning a handwheel toword you.
5. Loosen screw "a" and turn the upper looper shifting cam "b" until the hook of the
looper follower "c" falls into the V-shaped holl ow of the cam "b" ʻSee View A ).
Check if a cam "b" and looper follower "c" are positioned as own in View B .
6. Fasten screw "a" and recheck if the upper looper shifting connector "d" is pulled
up by a spring.
view A
1.0~1.5mm
view B
b
c
& UPPER LOOPER SHIFTING CAM
4THREAD" (See and Check Page E).
b
B
d
c
a
A
8
a
2 mm
b
c
F