1. If
"L0 or L1" needle thread is being pulled to the right (Fig. 1), then check the following
points:
2. Insert new needles (No. 90).
3. Check and make sure that needles are correctly inserted into the needle clamp.
4. Check and make sure that the needle (L0 or L1) is not touching the needle plate holes.
If necessary,check adjustment on page 3.
relation to the needle plate
ANNEX
TROBLE SHOOTING - COVER HEMS
- cover hems stitch being pulled -
holes".
L0
L1
"Height and orientation of needle bar in
Blue
Red
Fig.1
54
a