Table of Contents
Advertisement
Operation
Adjusting the flame
As the outer part of the flame is much
hotter than the center, the tips of the
flames should stay beneath the pan
base. Flame tips which extend beyond
the sides of the pan merely warm up
the air in the room and can damage
pan handles and increase the risk of
injury.
There is a stopper at the 6 o'clock po-
sition to prevent you turning the knob
to the high or low setting unintention-
ally. Press the knob down to move
past this resistance.
Adjust the flame so that it does not
spread out beyond the sides of the
pan.
To move from the high to the low set-
ting, turn the knob counterclockwise
until it stops. Then press it down and
continue to turn it past the resistance
before releasing it. You can now se-
lect the setting you require.
To move from the low to the high set-
ting, turn the knob clockwise until it
stops. Then press it down and con-
tinue to turn it past the resistance be-
fore releasing it. You can now select
the setting you require.
26
Visual features of gas flames
Switching off
Turn the control knob clockwise to
the position.
This stops the flow of gas and the flame
goes out.
Yellow flames
Call Customer
Service.
Yellow tips on
the outer cone
Normal for LP gas
Pale blue flames
possibly with yel-
low tips on the in-
ner cone
Normal for natural
gas
Advertisement
Table of Contents
