Adjusting The Flame; Switching Off - Miele ProLine CS 1018 G Operating And Installation Instructions

Operation

Adjusting the flame

As the outer part of the flame is much
hotter than the centre, the tips of the
flames should stay beneath the pan
base. Flame tips which extend beyond
the sides of the pan merely warm up
the air in the room and can also
damage pan handles and increase the
risk of injury.
There is a resistance at the 6 o'clock
position to prevent you turning the
control to the high or low setting
unintentionally. Press the control knob
down to move past this resistance.
 Adjust the flame so that it does not
spread out beyond the sides of the
pan.
 To move from the high to the low
setting, turn the control anti-
clockwise until it meets a resistance.
Then press it down and continue to
turn it past the resistance before
releasing it. You can now select the
setting you require.
 To move from the low to the high
setting, turn the control clockwise
until it meets a resistance. Then press
it down and continue to turn it past
the resistance before releasing it. You
can now select the setting you
require.
26

Switching off

 Turn the rotary control clockwise to
 burner off.
The gas supply is cut off and the flame
goes out.