About The Link Control - Panasonic PT-LMZ460 Operating Instructions (Functional Manual)

f If you cannot operate the operation menu of a CEC-compatible device, try setting the [PROJECTOR SETUP] menu → [HDMI CEC] to [OFF]
and [ON] again. It may be improved.
f While the HDMI-CEC operation screen is displayed, only the number buttons on the remote control can be used and other button operations
are disabled.
Menu operation of CEC-compatible device
When the setting menu of the CEC-compatible device is displayed, you can use the ▲▼◀▶buttons and
<ENTER> button of the remote control to operate the menu.

About the link control

By setting the [PROJECTOR SETUP] menu → [HDMI CEC] → [PROJECTOR -> DEVICE] / [DEVICE ->
PROJECTOR] to a setting other than [DISABLE], the following link operations can be achieved.
The link control setting of [PROJECTOR -> DEVICE]
r When the setting is [POWER OFF] or [POWER ON / OFF]
f If the projector is switched off, all connected CEC-compatible devices are switched off.
r When the setting is [POWER ON / OFF]
f When the projector is switched on and starts projection, the CEC-compatible devices connected to the <HDMI
IN 1> terminal or <HDMI IN 2> terminal are switched on upon startup of the projector.
The link control setting of [DEVICE -> PROJECTOR]
r When the setting is [POWER ON] or [POWER ON / OFF]
f While the projector is in standby, if the CEC-compatible device is turned on, the projector turns on and switches
to the input that the CEC-compatible device is connected.
f While the projector is in standby, if the CEC-compatible device starts playing, the projector turns on and
switches to the input that the CEC-compatible device is connected.
f While the projector is turned on, if the CEC-compatible device starts playing, the projector switches to the input
that the CEC-compatible device is connected.
r When the setting is [POWER ON / OFF]
f When the CEC-compatible device connected to the <HDMI IN 1> terminal or <HDMI IN 2> terminal is switched
off, the projector enters standby mode.
Note
f Depending on the status of the device, such as when the projector or the CEC-compatible device is starting up, the link control may not
operate normally.
f If the CEC-compatible device does not support CEC 1.4, it may not support the link control described in the manual.
f Depending on the connected CEC-compatible device, the link control may not operate normally.
Chapter 5 Operation of Function - Using HDMI-CEC function
ENGLISH - 135