Led Behavior - Tait TP9600 User Manual

• Place just a battery in the charger, or a radio with a battery attached (desktop charger or 6-way charger only).
There is no need to remove a belt clip, antenna, or any accessory that is attached to the accessory connector.
The red LED lights up and stays lit while the battery charges.
When charging is complete, the green LED stays lit.

LED Behavior

If there is a battery in the charger when power is supplied to the charger, the LEDs behave as follows:
(briefly)
(steady)
(steady)
(steady)
or
(flashing)
(all off)
If the charger does not behave as expected:
• Make sure the radio or battery is seated properly in the charger. For the vehicle charger, see also
Radio into the Vehicle
• Check that the charger is properly plugged into the originally supplied power supply.
• Check that the battery and charger contacts are clean. To clean, wipe the contacts with a dry lint-free cloth to
remove any dirt, oil or grease.
96
Tait International Ltd July 2021
Meaning
The charger has been connected to a power supply.
The battery is charging.
Charging complete. Remove the battery, or leave it in the charger.
The battery temperature is outside the normal charging range. Charging will start or
resume once the temperature is within normal limits. No action is required by you.
There is a fault. Contact your dealer.
If the LEDs for all charger slots continuously flash orange, or red then orange, the char-
ger itself may be faulty (e.g. the 6-way charger fan may be jammed). Contact your
dealer.
There is a fault. Contact your dealer.
Charger.
Inserting the