Table of Contents
Advertisement
Attaching a belt clip
To attach a belt clip to the radio:
1. Slide the belt clip into the two grooves at the top of the battery.
2. Press down on the belt clip until it snaps into place.
Removing a belt clip
The belt clip has been designed to prevent accidental removal, but it can be
removed, if required.
To remove a belt clip from a battery:
1. Insert a flat screwdriver blade or similar flat object under the lip
of the release lock (that is, between it and the metal slider).
2. Lift the release lock up (away from the metal slider) and hold it
in position.
3. Slide the belt clip out.
Installing an audio accessory
Use only Tait-supplied, or Tait-approved audio accessories with Tait radios. Fitting
an audio accessory that is not Tait-approved exposes the customer to a risk of
explosion which could cause serious injury or death. For an up-to-date list of
approved audio accessories, contact your regional Tait office.
Audio accessories plug into the radio's accessory connector. The accessory connector is protected by a cover, which
needs to be removed before an accessory can be installed.
The accessory cover protects the accessory connector from electrostatic discharge. Keep the
Notice
cover in place unless the connector is in use.
To remove the accessory cover and install an audio accessory:
1. Use a coin or other blunt object to loosen the screw that secures the accessory cover to the radio.
2. Remove the accessory cover and store it in a safe place.
22
Tait International Ltd July 2021
Advertisement
Table of Contents
