Lubrication - Jet JJ-6CSDX Operating Instructions And Parts Manual

13. To re-install the cutterhead, reverse the above
steps.
Note: Make sure that the fence base casting is
level with the Outfeed table when securing.

Lubrication

Use a good grade of light grease on the steel
adjusting screws located in the raising and
lowering mechanisms of the work tables.
Occasionally, apply a few drops of light
machine oil to the infeed/outfeed gibs. This
permits the tables to slide freely.
The cutterhead ball bearings are lifetime lubricated
and need no further care.
27
Figure 45