Dubbing (Multi-Dubbing) - JVC JX-S333-J Instructions Manual

Dubbing (Multi-dubbing)

Do not connect the AC power cord until all other connections have been made.
You can dub a video program from VCR 1 to VCR 2 and vice versa.
This shows an example of several possible connections. Also refer to the instruction books of the other components you are using
for operation and connection details.
Connection tips
• Before making any connections, turn off the power to all
components.
• It is not required to connect the components using both S-
VIDEO and component video connectors. To obtain the best
possible playback picture on the TV monitor, connect the
component using the component video connectors.
However, to dub the tapes, it is required to connect the
playback components through the S-VIDEO connectors.
• If both the S-VIDEO and component video connectors are
connected between the components, the incoming signals
are emitted through the respective output connectors.
(☞ P. 7 "Video input/output signals")
12
-EN
VCR1 (Playback component)
JX-S333
rear panel
VCR2 (Recording device)
• The INPUT 1 and INPUT 2 connectors are used for
: Signals from VCR 1 to VCR 2
: Signals from VCR 2 to VCR 1
To Component Video Input
(green) (green)
(blue) (blue)
(red) (red)
To AUDIO Input
(white)
(red)
To S-VIDEO Input
connecting the playback/recording components. Incoming
signals from the INPUT 1 and INPUT 2 connectors are
emitted through the MONITOR OUT connectors and at
the same time...
– Signals from the INPUT 1 connectors are emitted
through the OUTPUT 2 connectors.
– Signals from the INPUT 2 connectors are emitted
through the OUTPUT 1 connectors.
(white)
TV monitor
(red)