Sony SS-CPX1 Service Manual page 20

HCD-CPX1
[AGING MODE]
• This mode can be used for operation check of CD section and
tape deck section.
CD section and tape deck section work in parallel.
If an error occurred:
The aging operation stops only an error occurred sections and
display then status.
If no error occurs:
The aging operation continues repeatedly.
Procedure:
1. Press the key to turn the power ON.
?/1
[FUNCTION]
2. Press the key to select "CD".
3. Set disc on the tray and set tape into the deck.
[REPEAT]
4. Press the key to "REPEAT" off.
[DSG]
5. Press three keys of
simultaneously.
6. Aging operations of CD and tape are started at the same time.
7. To release this mode, press the
1. Display at the Aging Mode
Display operating state of CD section and tape deck section
alternately.
If an error occurred, stop display which that section.
2. CD Section
The sequence during the aging mode is following as below.
Display at the aging mode is the same as the normal operation.
Aging mode sequence (CD section) :
Start
Disc chucking
TOC read
Play first track for 2 seconds
Play last track for 2 seconds
Open the disc tray
Close the disc tray
18
[PLAY MODE]
, and x (TAPE)
?/1 key.
3. Tape Deck Section
The sequence during the aging mode is following as below.
If an error occurred, stop display that step.
Display at the aging mode is "TAPE AG—".
Aging mode sequence (Tape deck section) :
Start
Rewind the tape
Shut off
FWD play the tape
2 minutes
Fast forward the tape
Shut off or 20 seconds
REV play the tape
2 minutes
[CD ERROR CODE MODE]
• This mode can be used for error display of CD section.
Procedure:
1. Press the key to turn the power ON.
?/1
[FUNCTION]
2. Press the key to select "CD".
[DSG]
3. Press three keys of ,
Note: Error code is not displayed on the liquid crystal display.
[CD SERVO TEST MODE]
• This mode used to ckeck operation of optical pick-up.
Procedure:
1. Press the ?/1 key to turn the power ON.
[FUNCTION]
2. Press the key to select "CD".
[DSG] [PLAY MODE]
3. Press three keys of ,
4. When the CD servo test mode is activated, optical pick-up moves.
[5 REPEAT OFF MODE]
• Number of repeat for CD playback is 5 times when the repeat
mode is "REPEAT". This mode is used to enables CD to repeat
playback for limitless times.
Procedure:
1. Press the key to turn the power on.
?/1
[FUNCTION]
2. Press the key to select "CD".
[DSG]
3. Press three keys of
simultaneously.
4. When the 5 repeat off mode is activated, "LIMIT OF" is
displayed on the liquid crystal display.
[CHANGE-OVER FUNCTION OF EXTERNAL INPUT]
• This mode is used to enable function of external input to change
over between MD and VIDEO.
Procedure:
1. Set to standby state.
2. Press two keys of and
?/1
3. The function of external input changes over to MD or VIDEO.
[REPEAT]
and simultaneously.
X
and X simultaneously.
, and (TAPE)
M L x
[FUNCTION]
simultaneously.