Sony SA-VE525 Instruction Manual

A
Micro Satellite System
SA-VE525
4-233-674-61(1)
English
WARNING
Precautions
To prevent fire or shock hazard, do not expose the
On safety
unit to rain or moisture.
• Before operating the system, be sure that the operating
To prevent fire, do not Cover the ventilation of the
voltage of the system is identical with that of your local
apparatus with news papers, table-cloths, curtains, etc.
power supply.
And don't place lighted candles on the apparatus.
• The unit is not disconnected from the AC power source
To prevent fire or shock hazard, do not place vases on
(mains) as long as it is connected to the wall outlet,
the apparatus.
even if the unit itself has been turned off.
To avoid electrical shock, do not open the cabinet. Refer
• Unplug the system from the wall outlet if it is not to be
servicing to qualified personnel only.
used for an extended period of time. To disconnect the
cord, pull the cord by grasping the plug. Never pull
Do not install the appliance in a confined space, such
the cord itself.
as a bookcase or built-in cabinet.
• Should any liquid or solid object fall into the system,
unplug the system's power cord and have the system
checked by qualified personnel before operating it any
further.
About this manual • AC power cord must be changed only at the qualified
service shop.
The instructions in this manual are for SA-VE525,
Sony Micro Satellite Systems.
On operation
• Do not drive the speaker system with a continuous
The SA-VE525 is a 5.1 channel speaker system
wattage exceeding the maximum input power of the
consisting of two front speakers, two rear speakers,
system.
one center speaker, and one subwoofer. It supports
• If the polarity of the speaker connections are not
Sony Digital Cinema Sound, Dolby* Pro Logic, and
correct, the bass tones will be weak and the position of
Dolby Digital and is thus gearedtowards the
the various instruments obscure.
enjoyment of movies.
• Contact between bare speaker wires at the speaker
terminals may result in a short-circuit.
* Manufactured under license from Dolby Laboratories.
• Before connecting, turn off the amplifier to avoid
"Dolby", "Pro Logic", and the double-D symbol are
damaging the speaker system.
trademarks of Dolby Laboratories.
If you encounter color irregularity on a
nearby TV screen
This speaker system is magnetically shielded to allow it
to be installed near a TV set. However, color
irregularities may still be observed on certain types of TV
sets.
If color irregularity is observed...
c Turn off the TV set once, then turn it on again after
15 to 30 minutes.
If color irregularity is observed again...
c Place the speakers further away from the TV set.
If howling occurs
Reposition the speakers or turn down the volume on the
amplifier.
On placement
• Do not set the speakers in an inclined position.
• Do not place the speakers in locations that are:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibrations
— Subject to direct sunlight
On cleaning
Clean the speaker cabinets with a soft cloth lightly
moistened with a mild detergent solution or water. Do
not use any type of abrasive pad, scouring powder or
solvent such as alcohol or benzine.
If you have any questions or problems concerning your
speaker system, please consult your nearest Sony dealer.
 2001 Sony Corporation
Printed in China
Subwoofer
Front (Right) Front (Left)
Center
超低音扬声器
前（右） 前（左）
中央
LINE IN
Ee Ee
3.5m 3.5m
3.5m
Amplifier
FRONT
放大器
E e
R L
eE Ee
R L
WOOFER OUT CENTER
REAR
10m 10m
Rear (Right) Rear (Left)
后（右） 后（左）
Ee Ee
Hooking up the system
Connect the speaker system to the speaker output
terminals of an amplifier.
Make sure power to all components (included the
subwoofer) is turned off before starting the hook-up.
Hookup A
This configuration is used when the amplifier is
connected to a DVD player, LD player, VCR or other
video devices.
Hookup B
Try this configuration instead of "Hookup A" in the
following situations:
—When there are no jacks on the amplifier for a
subwoofer.
—When you want a stronger bass sound from the
subwoofer.
Notes (C)
• Make sure the plus (+) and the minus (–) terminals on
the speakers are matched to the corresponding plus (+)
and minus (–) terminals on the amplifier.
• Be sure to tighten the screws of the speaker terminals
securely as loose screws may become a source of noise.
• Make sure all connections are firm. Contact between
bare speaker wires at the speaker terminals may cause
a short-circuit.
• Do not connect the subwoofer to the amplifier's
CENTER output terminal (which is for Dolby Pro Logic
or Dolby Digital). No bass sound will output from the
subwoofer if you do.
• For details regarding the connections on the amplifier
side, refer to the manual that was provided with your
amplifier.
Tip
All striped wires are minus (–) in polarity, and should be
connected to the minus (–) speaker terminals.
Front (Left)
B Front (Right)
Center
前（左）
前（右）
中央
Ee
Subwoofer
超低音扬声器
3.5m
2.5m L L
e
E
E
3.5m
e
Amplifier
2.5m
R R
放大器
FRONT
SPEAKER SPEAKER
E e
R L IN OUT
eE Ee
R L
CENTER
REAR
10m 10m
Rear (Right)
Rear (Left)
后（右）
后（左）
Ee
中文
警告
为防火灾或触电危险，请勿让机器暴露于雨中或潮湿处。
为防止火灾，请勿用报纸、桌布、窗帘等覆盖本装置的
通风口。请勿将点燃的蜡烛放在本装置上。
为防止火灾或电击的危险，请勿在设备上放置装满液
体的物品，例如花瓶。
为免遭触电， 请勿擅自打开机壳。 维修限请找持有资格
者为您服务。
不要把装置安装在诸如书橱或壁橱等密闭的地方。
关于本说明书
本说明书用于说明 ＳＡ－ＶＥ５２５ Ｓｏｎｙ 微型卫星系统。
ＳＡ－ＶＥ５２５ 是含有两个前扬声器，两个后扬声器，一个中
央扬声器和一个超低音扬声器的 ５．１ 声道扬声器系统。
提供 Ｓｏｎｙ 数码电影院音响 （Ｓｏｎｙ Ｄｉｇｉｔａｌ Ｃｉｎｅｍａ
Ｓｏｕｎｄ），杜比＊专业逻辑和杜比数码功能，而供您用于享
受电影的音响。
经杜比实验室授权生产。
"杜比" ， " Ｄｏｌｂｙ" ， " Ｐｒｏ Ｌｏｇｉｃ" 和双 Ｄ 标志是杜比实
验室的商标。
C
Ee
3.5m
e
e E
e
E
E
Ee
使用前须注意 联结系统
将扬声器系统连接到一个放大器的扬声器输出端子。
安全须知
开始连接工作前，必须先关掉所有装置（包含副低音扬
• 操作系统之前，一定请先确认系统的操作电压是否与当地
声器）的电源。
的电源电压一致。
• 机器只要是电源线仍接插在墙上电源插座，则即使关掉机
器上的电源开关，机器仍并没有完全断开 ＡＣ 主电源的。 A 式联结
这个配置是用于放大器连接了 ＤＶＤ 播放机、ＬＤ 播放
• 准备长期不使用系统时，请自电源插座拔下系统的电源
机、录影机或其它视频装置时的用途。
线。要卸下电源线时，必须抓住插头拔下，不可拉着电源
线的导线部分拔。
• 万一有任何液体或杂物掉进系统里面时，即请自电源插座 B 式联结
拔下系统的电源线并找持有资格的人检查过以后才可再接
如下状况时，可试用此配置代替"A 式联结"：
电使用。
—当放大器上没有副低音扬声器用的插孔时。
• 要更换 ＡＣ 电源线时，必须找持资格的维修店为您服务。 —当想获得较强的，来自副低音扬声器低音时。
操作须知 注 （C）
• 不要连续地用超过系统的最大输入功率驱动扬声器系统。
• 须确认扬声器上的 （＋） 和 （－） 端子是否符合放大器上相
• 扬声器接线电极如果没有连接正确，低音将显得微弱而各
当的 （＋）、（－） 端子。
种乐器的位置也显得模糊不清。
• 一定请系紧扬声器端子的螺钉。因为螺钉松了，可能发生
• 扬声器各端子间的扬声器裸线部分相接触时，可能引起短
噪声。
路。
• 确认所有的连接部分是否都连接得稳固。扬声器各端子间
• 连接系统之前，须关掉放大器电源以免损坏扬声器系统。
的扬声器裸线部分相接触时，可能引起短路。
• 不要把副低音扬声器连接到放大器的 ＣＥＮＴＥＲ（中央）输
如果靠近的电视机荧幕遭遇彩色不均时
出端子（杜比专业逻辑或杜比数码用）。如果这样做，副
本扬声器系统为磁屏蔽型设计，可以装在电视机旁。但
低音扬声器将不能输出低音。
某些型式的电视机仍可能发生彩色不均的问题。
• 放大器一边的连接有关详细，请参照放大器附带的说明
书。
如果发生彩色不均...
c 即请关掉一下电视机电源，然后在 １５ 到 ３０ 分钟之后
再打开电源。
要领
如果又发生彩色不均现象... 所有具有条纹线皮的电线都是负 （－） 极，须连接到负 （－）
的扬声器端子。
c 即把扬声器移离电视机远些放置。
如果发生啸声
请重新配置扬声器，或转小放大器的音量。
安放须知
• 不要把扬声器放置在倾斜位置。
• 不要把扬声器装在如下位置：
— 太热或太冷的地方
— 极多尘垢的地方
— 极潮湿的地方
— 会受振动的地方
— 会直接照射到阳光的地方
清洁须知
请用软布轻蘸湿温和的洗涤剂溶液或清水擦拭机壳。切
勿使用任何型式的沙布，抛光粉或如酒精，汽油等溶剂进行
清洁。
关于扬声器系统，如果尚有疑问时，请洽询附近的
Ｓｏｎｙ 销售店。
e
E