Agilent Technologies 8753ES Datasheet page 15

External source mode 1 (CW time sweep only)
Frequency range
R-channel input requirements
Power level
Spectral purity
Maximum spurious input <-30 dBc
Residual FM
Typical settling time
Frequency readout accuracy
Input frequency accuracy requirement
Manual
Accuracy
Magnitude characteristics
Dynamic accuracy
Display resolution
Marker resolution 3
Trace noise
(0 dBm at transmission port or +5 dBm at reflection port,
ratio measurement, 3 kHz BW)
300 kHz to 3 GHz
3 GHz to 6 GHz
1. See the Agilent 8753ET/ES descriptions and options for a functional description.
Measurement accuracy is dependent on the stability of the input signal.
2. Typical performance.
3. Marker resolution for magnitude, phase and delay is dependent upon measured
value. Resolution is limited to five digits.
300 kHz to 6 GHz
2
0 to -25 dBm
<20 kHz
500 ms (automatic)
50 ms (manual)
2 0.1% (automatic)
2
-0.5 to 5 MHz
(See magnitude and phase
characteristics)
(10 Hz IF BW)
0.001 dB/division
0.001 dB
<0.006 dB rms
<0.010 dB rms
Reference level
Range
Resolution
Stability 2
300 kHz to 3 GHz
3 GHz to 6 GHz
Phase Characteristics
Dynamic accuracy (10 Hz IF BW)
Range
Display resolution
Marker resolution 3
Trace noise
(0 dBm at transmission port or +5 dBm at reflection
port, ratio measurement, 3 kHz BW)
300 kHz to 3 GHz
3 GHz to 6 GHz
Reference level
Range
Resolution
Stability
30 kHz to 3 GHz
3 GHz to 6 GHz
Polar characteristics
Range
Reference
±500 dB
0.001 dB
0.02 dB/1° C
0.04 dB/1° C
±180°
0.01°/division
0.01°
<0.038° rms
<0.070° rms
-180° to +180°
0.01°
0.05°/° C
0.20°/° C
10 x 10 –12 to 1000 units full
scale
±500 units
15