Rinse Aid - Asko D5233 Use & Care Manual

Rinse aid

Pour in rinse aid
Rinse aid, helps quicken the drying process.
Machines with indicator on the
panel
When the rinse aid has run out and more is
needed, the rinse aid symbol on the panel
lights up*.
To fill with rinse aid:
1. Turn and lift up the cover of the rinse aid
compartment to the right of the dispenser.
This is where you top up and set the amount
of rinse aid to be dispensed in each wash.
2. Carefully pour in rinse aid up to the knob
for dosage setting.
Alter dosage if required. Do not forget to
close the cover.
*NB!
After filling there may be a short delay be­
fore the signal light goes out.
Machines with refill indicator
There is a refill indicator in the middle of the
dispenser (see picture). If the refill indicator
is totally black, there is sufficient rinse aid.
However, if the indicator has a more trans­
parent appearance, you need to top up with
rinse aid (see above).
Refill indicator
Cover for rinse aid
Open by turning and lifting the cover!

Open
Closed
Select dosage
The dispenser is usually set at 1= soft water.
However, depending on the water hardness,
it may be necessary to change the dosage.
Open the rinse aid cover . Here you will find
the dispenser's adjustment dial. Settings 1­6:
the harder the water, the higher the dosage.
When the water hardness exceeds 10­12
you should use rinse aid with citric acid (acid
rinse aid) if the machine does not have a
water softening filter. If the machine has a
water softening filter, dispense as for soft
water.
Too much rinse aid can lead to the build­up
of foam. If your water is particularly soft, you
can dilute the rinse aid (1 part rinse aid, 1
part water).
Too much rinse aid can cause streaks on
the dishes, while too little can result in water
stains.
dH
o