12. Remove the shipping plugs and attach the hydraulic hoses
from the attachment pump to the tractor pump as shown in
Figure 8.
13. Attach the disconnected lift-cylinder hoses to the attachment
lift cylinder. Attach the long hose to the elbow fitting and the
short hose to the extension hose as shown in Figure 9.
a
Elbow Fitting
14. Route the two-wire harness from the attachment reel-control
switch (Figure 10) through the p-clip on the weldment, then on
top of the frame along the engine to the back side of control
panel.
Figure 8
Extension
Hose
Figure 9
Reel-Control
Switch
Wire Harness
15. Locate the purple/white-stripe wire leading to the PTO switch.
Cut the wire, strip away a small amount of insulation and install
bullet connectors on each end of wire. Connect reel-control
switch wiring harness to bullet connectors. See Figure 11.
PTO Switch
Cut
purple/white-stripe
wire and install
bullet connectors.
Reel-Control
Switch
Harness
GB - 8
Figure 10
Figure 11
OP2012