Table of Contents
Advertisement
7. Install cylinder limiter to tilt cylinder. See Figure 4. Ensure that
washers are installed correctly and that limiter does not
contact the cylinder.
Tilt Cylinder
5
3
4
1. 1/2 x 4-In. Hex Bolt
2. 1/2-In. Flat Washer
3. 1-1/4 x 3/4 x 1/8-In. Washer
4. Bushing
5. 1-1/4 x 17/32 x 1/4-In. Washer
6. Limiter
8. Using an overhead hoist or fork lift position the attachment at
the front of the tractor.
9. Route the two lift cylinder hydraulic hoses disconnected earlier
through the slot in rear of the attachment frame. See Figure 5.
Slot
10. Mount the cutting attachment to the tractor with eight 5/8 x
1-3/4 hex bolts and Nyloc hex nuts on the sides and two 1/2 x
1-1/2 In. hex bolts and Nyloc hex nuts on the front. Tighten the
front hardware before tightening the side hardware. See
Figure 6.
6
3
1
2
Figure 4
Figure 5
3, 4
1. 5/8 x 1-3/4-In. Hex Bolt
2. 5/8 In. Nyloc Hex Nut
3. 1/2 x 1-1/2 Hex Bolt
4. 1/2 In. Nyloc Hex Nut
11. Install drive belt onto attachment pump pulley and the tractor
clutch pulley. Make sure that belt and idler are routed as
shown in Figure 7.
Tractor Pump Drive
Belt
OP2016
GB - 7
1, 2
1, 2
Figure 6
Tractor
Pump Drive
Belt
Attachment Pump
Drive Belt
Attachment
Figure 7
Idler
3, 4
Advertisement
Table of Contents
