Table of Contents
Advertisement
T
S
ERMINAL
ETUP
VX 520 Setup
WARNING
NOTE
36
VX 520 I
NSTALLATION
Figure 30
VX 520 GPRS Power Connection
3
Rotate the power plug counter-clockwise and flush against the side panel to
lock the plug in place.
4
Route the cable in the direction of the arrow above the power port and sling
the cable over the underside of the thermal paper container.
5
Close the terminal rear cover.
6
Insert the AC power cord into the power pack (for VX 520 D/E models).
7
Plug the AC power cord into a wall outlet or powered surge protector.
Do not plug the power pack into an outdoor outlet or operate the terminal
outdoors.
Disconnecting the power during a transaction may cause transaction data files
not yet stored in terminal memory to be lost.
To protect against possible damage caused by lightning strikes and electrical
surges, consider installing a power surge protector.
VeriFone recommends connecting wall power in the following order:
1
Connect the terminal to the power supply.
2
Connect the power supply to the power cord.
3
Connect the power cord to the wall outlet.
When the terminal has power, the terminal lights are activated and the LED
indicator remains lit.
If an application is loaded in the terminal, it starts after the initial VeriFone
copyright screen and usually displays a unique copyright screen. If no application
is loaded in the terminal,
VeriFone copyright screen.
G
UIDE
B
DOWNLOAD NEEDED
A
appears on screen after the initial
Advertisement
Table of Contents
