Bajaj Pulsar N160 Owner's Manual page 26

Before riding motorcycle be sure to check following items.
Please give proper importance to these checks and perform all
of them before riding motorcycle. If any irregularities are found
during these checks, refer to the Maintenance chapter & see
your dealer for the action required to return the motorcycle to
a safe operating condition.
Warning: Failure to perform these checks every day before you
ride may result in serious damage or severe accident.
• Enough fuel level for planned distance of journey. No fuel leakage
in fuel lines.
• Engine oil level (between upper and lower level mark)
• Throttle cable play of 2 - 3 mm. Smooth operation and positive
return to closed position,
• Brake Fluid level above MIN mark provided on Front & rear
reservoir
• Drive Chain slack of 20-30 mm adequately lubricated. •
Function of all lights & horn
• Clutch lever play - 2 to 3 mm
• Smooth steering movement without restriction.
• Side stand return to It's fully up position.
/ INSTRUCTIONS FOR CUSTOMER
• Correct ination pressure in both tyres. Adequate tyre
tread depth - no cracks / cuts.
• Correct rear viewing span adjustment of mirror.
• Cleaning cloth not to be kept in vicinity of high temperature
zone e.g. Oil cooler, engine, silencer assembly, starter motor
etc.
• Cleaning cloth to be kept in LH/RH seat cowl.
Instructions for Customer
• There is no fuel cock.
• Always maintain minimum 3
tank.
• Don't use fuel additives as it will result in rusting &
clogging of Injector, Fuel pump module & catalytic
convertor.
• If vehicle is tilted beyond 60 Deg, then Roll over
sensor cuts off Ignition system as a safety feature.
• Never drive by disconnecting wheel speed sensor as
ABS unit will not function.
22
Liters
petrol in fuel