Bajaj Pulsar N160 Owner's Manual page 13

Speedometer display will work when Ignition switch is in 'ON'
position.
1. Tachometer Dial: It shows engine speed in RPM.
2. Gear Indication ( ): It will display gear position from 1 to 5. It
GEAR
will display 0 when vehicle is in neutral position.
3. High Beam Indicator ( ): It glows when Headlight is ON & High
beam is selected with engine running.
4. Turn Signal Indicator ( ): When Turn signal switch is pushed
to Left or Right, Turn Signal Indicator - LH or RH will flash.
5. Side Stand Indicator: It glows when side stand is down
Side Stand
Gear position
Condition
Engine in neutral gear position Self-start / kick start possible
Shifting gear from 'N' to 1st
Down
gear in engine start condition
by pressing clutch lever
Down Engine in gear position
6. Malfunction Indicator ( ): It glows whenever any abnormality
is noticed in functioning of Fl system related components.
7. Low Battery Indicator:( ) It indicates battery needs charging.
8. Low Oil Pressure Indicator (
pressure is low.
9, Mode Button: Mode button used for toggling between different
modes e.g. ODO, Trip1, Trip2, DTE and clock setting.
Remark
Engine will get cut off
Engine will not start by self-
start / kick start.
): It glows when engine oil
9
10. Set Button: Set button used for toggling between ODO to
IFE, Trip1 to AFE1,Trip2 to AFE2,DTE to distance to next
service and clock setting.
11. Engine REV Indicator: ( ) It glows when engine RPM exceed
RPM
LIMIT
9000 RPM. It indicates customer "Not to REV up engine
beyond safe engine operating RPM.
12. ABS Indicator ( ): With Ignition switch ON the ABS
indicator glows. When vehicle speed is more than 5 Km/h the
ABS indicator goes off, if this indicator glows while vehicle is
running, it means there is problem in ABS.
13. Neutral Indicator: ( ) When the transmission is in Neutral,
Neutral indicator will glow.
14. Odometer: The Odometer shows the total distance that the
vehicle has covered. Odometer can not be reset to 'Zero'.
15. Trip Meter: Selected Trip meter shows the distance traveled
since it was last reset to zero. Both trip meters can be reset
to zero by pressing the Set button. After completion of max
value of 999.9 Km, selected trip display will get freezed and will
not get set automatically to zero.
16. Fuel Level Indicator:( ) It shows available fuel in fuel tank.