Bajaj Pulsar N160 Owner's Manual page 21

CONTROL SWITCH RH - AHO
Applicable for N160 single channel ABS vehicles
E. Starter Button:
Starter button operates the electric starter. It is recommended
to start the engine with the transmission in neutral.
Vehicle in Gear - Press clutch lever & operate starter button to
start the engine.
F. Engine Kill Switch:
The engine kill switch is used for switching ON & OFF the engine. :
: Engine OFF
: Engine ON
AHO (Automatic Headlight 'ON')
There is no 'Light Switch' on RH control switch.
F
Ignition switch 'ON'
Engine 'OFF'
Effect of pressing
'Pass switch'
E
Ignition switch 'ON' & Engine Running
Speedometer illumination, tail lamp, number plate lamp, pilot
lamp will get 'ON' in addition to above, head lamp will get
ON as given below
Hi/Low
Beam
switch
Low Beam
Hi beam
17
Speedometer illumination
will get 'ON'
In addition to above
Hi-beam will get 'ON' &
high beam indicator will
get ON
Head Lamp Effect to
Beam Status Pass Switch
Low Beam Hi Beam
'ON' 'ON'
Hi beam No change
'ON'