Table of Contents
Advertisement
O
perations
Getting ready
1. Attach mop pad
A. Set the mop pad flat on the floor
B. Line up the mop head and place it
inside the mop pad with cord located
at rear of mop head. Tighten cord to
ensure tight fit.
2. Fill water tank
A. Remove tank by lifting straight up and
away from the unit.
B. Unscrew cap and remove from tank.
C. Fill water tank with water. For best results,
water should be at room temperature.
D. Replace the assembly cap and tighten
until snug.
E.
Replace water tank by lining up verti-
cal guides and gently sliding tank into
place.
3. Select a steam control setting. Light is for
delicate floors such as hardwood and lami-
nates. Normal is for everyday cleaning, and
Tough is for hard to clean messes.
4. Twist the Quick Release
wise to unwrap the power cord completely
and plug into a 220V-240V grounded
outlet as described on the Important
Safety Instructions, page 3.
5. The ready light will illuminate in 30
seconds when the Lift-Off Steam Mop is
ready for use.
Before you clean
Thoroughly sweep or vacuum floor prior
to cleaning with the Lift-Off Steam Mop.
Cleaning hard floors
Your Lift-Off Steam Mop is designed to
clean hard flooring such as ceramic tile,
vinyl, laminate, marble, stone and sealed
hard wood floors. Use of your Lift-Off
Steam Mop on waxed or some unwaxed
floors may result in a diminished glossi-
ness. The Lift-Off Steam Mop is not for
use on unsealed wood floors. For best
results test in an inconspicuous area and
check the care instructions from your
flooring manufacturer.
w w w . b i s s e l l . c o m
™
cord wrap clock-
2A
2D
2B
2E
7
Advertisement
Table of Contents
