Before You Clean - Bissell Steam&Sweep 57F4-J Series User Manual

O
perations
c. fill the water tank with water. for
best results, water should be at room
temperature.
d. Replace the insert assembly and cap,
tighten until snug.
e. Replace the water tank by lining up
the vertical guides and gently sliding it
back into place.
3. Twist the quick release cord wrap
clockwise to unwrap the power cord
completely, make sure both switches are
in the "off" position and plug it into a
proper outlet.
4. Turn power button on. The ready light
will illuminate when the Steam&Sweep is
ready for use.
note: upon first use of the
steam&sweep or first use of a
new filter, the pump may make a
"knocking" sound while the filter
fills with water. this sound is normal
and may last a couple of minutes.
continue to depress the trigger until
the knocking sound subsides and
the unit emits steam. if the sound
continues, please make sure the
tanks are firmly secured."

before you clean

the steam&sweep can be used as
a sweeper and a steam mop at the
same time. for best results, use the
steam&sweep's powerful sweeper
to clear floor of dust and small
debris before mopping.
1. Turn the brush switch to the on ( i )
position to activate the brush.
2. To empty the dirt container, turn the
power off, gently tap the release
pedal on the swivel head. Lift unit
straight up leaving bin on floor and
empty into a trash can. The dirt
container may be warm to the touch.
w w w . b i s s e l l . c o m
2d.
2e.
WaRning:
Steam&Sweep will not pick
up crayons, marbles, and
other large objects.
1.
Brush Switch
Dirt Bin
2.
Release Pedal
Power Switch
7