Advertisement
ASSEMBLY AND SETUP
Attaching the Front Fork (Continued)
Required Tools: 13 mm Wrench and 5 mm Allen Wrench (included)
3
Be sure to properly align the slot on the headtube
with the pin on the front fork as shown.
WARNING: Failing to properly tighten the steering bolt that attaches the front fork assembly to the frame assembly can
cause you to lose control and fall.
Attaching the Front Wheel
Required Tools: 5 mm Allen Wrench and 10 mm Wrench (included)
1
Remove the four (4) coupling
bolts from the front fork using
a 5 mm Allen wrench and a
10 mm wrench.
Attaching the Seat
Required Tools: Two (2) 5 mm Allen Wrenches (included)
1
Using two (2) 5 mm Allen
wrenches, remove the four (4)
coupling bolts from the frame.
2
Insert the wheel assembly into
the front fork and align holes. When
installing the wheel, make sure the
letter "F" and arrow (located on
the side of the wheel) are facing the
direction as shown above.
2
Align the four (4) holes in seat with the four (4) holes
in frame. Insert the coupling bolts through the top and
bottom of the frame. Note: The holes in the frame allow
for one (1) of two (2) seat positions to be selected when
installing the seat to the frame.
4
Reinsert the steering bolt and secure with locknut
using a 13 mm wrench and a 5 mm Allen wrench.
3
Reinsert the coupling bolts
through the front fork and
tighten securely.
3
Tighten the coupling bolts using
two (2) 5 mm Allen wrenches.
5
Advertisement
