Carrier Alarko 6 Instruction Manual page 11

!
Minimum well diameter has to be larger than the pump diameter.
!
Electric supply values (voltage, phase, current density and frequ-
ency) are stated on the pump label. Electric mains supply has to
correspond to these values.
CORRECT AND SAFETY USAGE
Usage Information
• Do not adjust with the thermic adjustment.
• Replace blown fuses with ones of equal value of your fuses are not au-
tomatic.
• Never leave protection elements of control panels such as phase protec-
tion and water level relay, switched off and never bridge them.
• Never start motor if the voltage does not match with that of the motor
label or if the voltage is not within tolerable limits stated in this booklet.
• Make sure the control panel is ventilated and protected against rain and
humidity.
• If you need an extension to the cable, have it made by an authorized
agent by taking into consideration not the colours at the ends of cables,
but the voltage at each end.
• Ensure that control panels are checked every six-month by an authorized
service agent and broken or inefficient parts are replaced.
• Do not use the control panel to supply electricity to any other unit or
ambience.
• If the pump needs any repair and is to be sent to Alarko Carrier Authori-
zed Service Agency, the control panel is to be sent as well.
• Do not use pumps without valves, and if there is a rising pipeline, do not
use them without a check valve.
• Do not remove the check-valve in your pumps. This sort of usage will
automatically cancel your guarantee.
11