Clarion DXZ735MP Owner's Manual page 17

Dimmer control
You can setting the dimmer control on or off.
The factory default setting is "ON".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button to select
"DIMMER".
3. Turn the [ROTARY] knob clockwise to "ON"
or counterclockwise to "OFF".
4. Press the [T] button to return to the previous
mode.
Adjusting the display contrast
You can adjust the display contrast to match the
angle of installation of the unit.
The factory default setting is "6". (Adjustment
level:1to 11)
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button to select
"CONTRAST".
3. Turn the [ROTARY] knob clockwise or coun-
terclockwise to adjust the contrast.
4. Press the [T] button to return to the previous
mode.
Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft. When the DCP is removed from
the unit, this indicator blinks.
The factory default setting is "OFF".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button and select
"BLINK LED".
3. Turn the [ROTARY] knob clockwise to set this
function "ON" or turn it counterclockwise to
switch this function "OFF".
4. Press the [T] button to return to the previous
mode.
Setting LOW PASS FILTER
The factory default setting is "LPF 120Hz".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
Operations Common to Each Mode
2. Press the [a] or [d] button to select
"SUB-W LPF".
3. Turn the [ROTARY] knob clockwise or coun-
terclockwise to select the setting. Each time
you turn the [ROTARY] knob, the setting
changes in the following order:
REAR LPF 50Hz
120Hz
4. Press the [T] button to return to the previous
mode.
Selecting AUX IN sensitivity
Make the following settings to select the sensi-
tivity when sounds from external devices con-
nected to this unit are difficult to hear even after
adjusting the volume.
The factory default setting is "MID".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button to select
"AUX SENS".
3. Turn the [ROTARY] knob clockwise or coun-
terclockwise as needed and select from
"HIGH", "MID" or "LOW".
4. Press the [T] button to return to the previous
mode.
Setting the clock
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button to select
"CLOCK".
3. Press the [ ] button.
4. Press the [a] or [d] button to select the
hour or the minute.
5. Turn the [ROTARY] knob clockwise or coun-
terclockwise to set the correct time.
The clock is displayed in 12-hour format.
6. Press the [ ] button to store the time into
memory.
7. Press the [T] button to return to the previous
mode.
Note:
• You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove the
car's battery or take out this unit, the clock is re-
set. While setting the clock, if another button or
operation is selected, the clock set mode is can-
celed.
LPF 80Hz LPF
21
DXZ735MP