Table of Contents
Advertisement
Provisioning
Unless a cut-through card is used on this port, keep the
default setting (133 feet) for Wideband 3190 applications.
3
Place the channel in service (IN-SRVC, OOS is default).
You have now provisioned your system. The procedures that follow
document additional system configurations.
Changing T1 to E1 Configurations for the Wideband 3190
or ACE Chassis
When changing from T1 to E1 ports, the fourth port of each
group is not used. All ports in the group of four will be
simultaneously switched.
To change T1 ports to E1 ports,
1
Select the port, by pressing the
MEM-ADMIN, then press
Repeat for all ports in the same group, such as 1-4, 5-8, or 9-12.
2
Select a port in the group and change the type of service from T1 to E1
by pressing the
3
Select each port again and change its Srvc Mode to IN-SRVC.
For more information about routing T1/E1 channels, see
Assignment Switch (TSA)" on page
22
SPACEBAR
ENTER
, then press
SPACEBAR
57.
April 6, 2001
LTPH-TP-1044-01, Issue 1
, change its Srvc Mode to
.
.
ENTER
"Time-slot
HXU-358 V1.04
Advertisement
Table of Contents
