Dimmer Control; Adjusting The Display Contrast - Clarion DXZ466MP Owner's Manual

Operations Common to Each Mode
• Adjusting the display scroll speed
This feature allows you to slow down the scroll
speed when the scroll speed is too fast, making it
difficult to view the screen.
∗ The factory default setting is "SPEED 3"
2-1. Select " SCRL SPEED".
3-1.Turn the [ ROTARY ] knob to select the setting.
∗ This setting item can be adjusted within the
range SPEED 1 to SPEED 6.
Adjust this setting item while viewing how the
appearance of the display changes.

• Dimmer control

You can setting the dimmer control "ON" or "OFF".
∗ The factory default setting is "ON".
2-1. Select " DIMMER".
3-1. Turn the [ ROTARY ] knob to select "ON" or
"OFF".

• Adjusting the display contrast

You can adjust the display contrast to match the
angle of installation of the unit.
∗ The factory default setting is "08".
( Adjustment level: 01 to 16 )
2-1. Select " CONTRAST".
3-1. Turn the [ ROTARY ] knob to adjust the
contrast.
To change other settings
1. Press the [ ADJ ] button to switch to the
adjustment selection display.
2. Press the [ ,
ward to select the "item name".
Each time the [
up/down, the item display changes in the
following order:
"BLINK LED"
"AUX SENS"
3. Turn the [ ROTARY ] knob to select the "desired
setting item".
∗ After completing settings, press the [ ADJ ] but-
ton to return to the previous mode.
22
DXZ466MP
] lever upward or down-
, ] lever is pressed
"AMP CANCEL"
"SYSTEM CHECK
Push ENT
• Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft. When the DCP is removed from the
unit, this indicator blinks.
∗ The factory default setting is "OFF".
2-1. Select " BLINK LED".
3-1. Turn the [ ROTARY ] knob to select "ON" or
"OFF".
• Setting the external amplifier
∗ The factory default setting is "OFF".
2-1. Select " AMP CANCEL".
3-1. Turn the [ ROTARY ] knob to select "ON" or
"OFF".
• ON:
Use with connected AMP.
• OFF:
Use with inside AMP.
• Selecting AUX IN sensitivity
Make the following settings to select the sensi-
tivity when sounds from external devices con-
nected to this unit are difficult to hear even after
adjusting the volume.
∗ The factory default setting is "MID".
2-1. Select " AUX SENS".
3-1. Turn the [ ROTARY ] knob to select "LOW",
"MID" or "HIGH".
• Triggered audio mute for cellular
telephones
This unit requires special wiring to mute the audio
signal automatically when a cellular telephone
rings in the car.
∗ This function is not compatible with all cellular
telephones. Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
• Performing a system check
"
This function allows you to perform a system check
from the adjust mode when required.
2-1. Select " SYSTEM CHECK
3-1. Press and hold the [
or longer.
"SYSTEM CHECK" appears in the display,
then the unit returns to the previous
operation mode.
".
Push ENT
] button for 1 second