Removing And Fitting The Appliance Door; Removing And Inserting The Hook-In Racks - Bosch HGL10E150 Instruction Manual

Remove the middle panel.
6.
Note: The middle panel is kept in place with rubber bushings
rather than retaining pins.
Clean the panels with glass cleaner and a soft cloth.
:
Risk of injury!
Scratched glass in the appliance door may develop into a
crack. Do not use a glass scraper, sharp or abrasive cleaning
aids or detergents.
Fitting the door panels
Reinsert the middle panel.
1.
Note: Make sure that the panel is seated correctly. All rubber
bushings must lay flat against the outer panel.
Reinsert the inner panel.
2.
Note: All four fastening pins must engage in the holders
provided for them.
Remove the locking pins and close the oven door.
3.

Removing and fitting the appliance door

If the oven is very heavily soiled, the oven door can be removed
for easier cleaning. Normally, however, this is not necessary.
Removing the appliance door
Open the oven door fully.
1.
Lock both hinges on the left and right using the locking pin
2.
(a).
Note: The locking pins must be fully inserted into the holes in
the hinges.
10
Grip the oven door on either side with both hands and close
3.
the oven door by approx. 30° (b).
Raise the oven door slightly and pull it out.
4.
Note: Do not fully close the oven door. The hinges could
become bent and the enamel could be damaged.
Fitting the appliance door
Grip the oven door on either side with both hands.
1.
Slide the hinges into the slots in the oven (a).
2.
Note: The notch below the hinges must engage into the
frame of the oven (b).
Lower the door downwards.
3.
Remove the locking pins.
4.
:
Risk of injury!
Do not reach into the hinge if the oven door falls out
unintentionally or a hinge snaps closed. Call after-sales service.

Removing and inserting the hook-in racks

You can remove the hook-in racks for easier cleaning.
Removing the hook-in racks
The hook-in racks are each fixed to the side panels of the
cooking compartment at three points.
Grip the front of the hook-in rack and pull it to the middle of
1.
the cooking compartment.
The front hook of the hook-in rack will release from the hole.
Fold out the hook-in rack further and pull it from the rear
2.
holes of the side panel.
Hold the catalytic cooking compartment panel in place.
3.
Remove the hook-in rack from the cooking compartment.
4.
Inserting the hook-in rack
Hold the catalytic cooking compartment panel in place.
1.
Insert the hooks of the hook-in rack into the rear holes in the
2.
side panel.
Press the front hook of the hook-in rack into the hole.
3.