Operating; Operating Instructions; Charging - Porsche Mobile Charger Connect Driver Manual

Operating

Operating instructions

In some countries, the relevant authorities must be
notified when you connect electric vehicle charging
equipment.
e
Check any obligations to notify the authorities
and legal requirements for operation before con-
necting charging equipment.
NOTICE
Damage to the charger
e
Always place the charger on a solid surface when

charging.

e
Porsche recommends that you operate the
charger in the basic wall mount or in the charg-
ing dock. In some countries, e.g. in Switzerland
the charger may only be used in the basic wall
mount or in the charging dock.
e
Do not immerse the charger in water.
e
Protect the charger from snow and ice.
e
Handle the charger carefully and protect it from
potential damage resulting from being driven
over, dropped, pulled, bent or crushed.
e
Do not open the charger housing.
NOTICE
Damage to the charger
1. Time of printing: Further information is available from your Porsche partner.
The charger must only be operated within a tempera-
ture range from –30 °C to +50 °C.
e
To prevent overheating during operation, avoid
continuous exposure of the charger to direct
sunlight. If the charger overheats, charging will
be interrupted automatically until the tempera-
ture has returned to the normal range.
e
If the charger is too hot or too cold, let it return
slowly to the operating temperature range and
do not actively cool it down or heat it, e.g. by
cooling it down with cold water or heating it with
a hairdryer.
,
1
Charging
Charging instructions
Vehicle charge port
For information on connecting and disconnecting the
vehicle cable to and from the vehicle charge port and
for the charging and connection status at the vehicle
charge port:
g Refer to the Driver's Manual.
Electric shock, fire
DANGER
Risk of serious or fatal injury due to fire or electric
shock.
e
Always observe the specified order for the
charging procedure.
e
Do not unplug the vehicle cable from the vehicle
charge port during charging.
e
End the charging process before disconnecting
the vehicle cable from the vehicle charge port.
e
Do not disconnect the charger from the electrical
socket during charging.
Errors are shown on the display and are indicated by
red status LEDs. The error message, the cause and a
remedial measure are displayed.
e
Refer to chapter "Malfunctions" on page 35.
Operating
23