Sony HDC-900 Maintenance Manual page 59

6. Disconnect the harness connectors from connectors
(VF, TOP SW, R FAN, REAR AUDIO, RM, POWER,
REAR VIDEO, F-MIC, INSIDE SW, TEST, LENS)
and flexible card wire from (INCOM PANEL) of MB-
882 board side-A.
n
Refer to Section 1-6 for details on disconnecting/
connecting the flexible card wire.
MB-882 board
VF TOP SW
A side
LENS
INSIDE F-MIC
TEST
SW
7. Remove the four screws, and remove the SDI shield.
8. Remove the three screws, and remove the MB-882
board.
MB-882 board
9. Install the new MB-882 board in the reverse order of
steps 1 to 8.
HDC-900/950 MM
R FAN
INCOM
PANEL
REAR
AUDIO
RM
REAR POWER
VIDEO
PS2.6 x 6
PS2.6 x 6
SDI shield
[Notes|at|installation]
. Before connecting the connection connector, clean the
white optical contact at the tip of connector with alcohol.
. Align the protrusion of the connector with the notch of
the interconnection connector in connecting.
Notch
(blue,white)
Interconnection
connector
3-14. Replacing the Boards
Protrusion
(yellow)
Optical contact (white)
3-23 (E)