Tie In Tool" Addendum - Panduit PAT1M Operation Manual

"TIE IN TOOL" ADDENDUM

Turning new "Tie in Tool" feature "ON" or "OFF"
Level 1 - Operator Menu ("Load, Unload, Menu" Display)
Loads: 14
Load
Level 1B - Loading commands disappear
Level 2 - SETUP MENU ACCESS
Resets load and/or counter
Reset Ld
Level 3 - Total Counts Menu
Shows total counts
Counters
LEVEL 3A - Dispenser and Tool Counts
PDM # XXXXXX
PAT1M # XXXXXX
If "Tie in Tool" feature is turned "ON" and you want to turn it "OFF", just repeat this process.
ERROR 6 - Tie in Tool
Tie in Tool
POSSIBLE CAUSE: This occurs if the cable tie reaches the tool, but is prevented from completing the cycle.
This may be due to a large air pressure drop, too large of a bundle; improper feeder hose connections, an
obstruction blocking the cable tie path; a severe bend or twist in the feeder hose, or the tool jaws are opened
during the cycle.
CORRECTIVE ACTION: Remove the cable tie and any obstruction from the jaw area. Resume operation.
PREVENTION: To prevent this problem from recurring, verify that the feeder hose connections are secure and
that there are no severe bends or twists in the feeder hose. Verify that the maximum bundle diameter does not
exceed .82" (21mm) for the PAT1M Tool; and 1.31" (33mm) for the PAT1.5M Tool. Also, verify that the air
pressure is between 65 and 85 PSIG (4,5 and 5,8 bar), with a maximum 10 PSI (0,7 bar) drop.
PAT1M/PAT1.5M: PA22222A01_03
Downloaded from Elcodis.com electronic components distributor
PAT1M / PAT1.5M OPERATION MANUAL
Unload MENU
MENU
Reset Ct
Escape MENU
Rev X.X
MENU
XXXXXXX
XXXXXXX
XXXXXXX
Exit
XXXXXXX
Exit
Cycles: XXXXXXX
Cycles: XXXXXXX
Buzzer
Page: 35 of 36
From either of these screens,
Press the MENU button
1. Press BUTTON 3, two times
2. Press BUTTON 1, one time
3. Brings up Level 3
(Note: Count buttons from left to right)
Press the COUNTERS button
1. Press BUTTON 3, two times
2. Press BUTTON 2, two times
3. Press BUTTON 3, one time
4. Then press BUTTON 4 to exit
5. Then press ESCAPE button
from Level 3 menu (above)
PDM Software, Revision 0.8 or higher
Dec., 2007