HP Spectre x360 Maintenance And Service Manual page 58

Remove the display assembly:
1. Remove the protective tape from the sides of the fans (1).
2. Disconnect the camera cable/touch connector (2) from the ZIF connector on the system board.
3. Disconnect the wireless antenna cables (3) from the WLAN module.
The #1/MAIN WLAN antenna cable connects to the WLAN module #1/Main terminal. The #2/AUX WLAN
antenna cable connects to the WLAN module #2/Aux terminal.
4. Release the camera cable/touch connector and wireless antenna cables from the clip on the left side of
the fan (4).
5. Disconnect the display panel cable (5) from the ZIF connector on the system board.
6. Open and rotate the display 180° so it is positioned next to the computer.
7. Remove the four Phillips M2.5 × 4.0 screws (1) that secure the display assembly to the computer.
8. Separate the display from the computer (2).
9. If you need to remove the display panel:
52 Chapter 5 Removal and replacement procedures for authorized service provider parts