Pk80F Control Sequences - Intermec PK80 Series User Manual

PK80F Control Sequences

Commands
LF (0Ah) Line Feed
CR (0Dh) Carriage Return A single CR prints and places carriage at end of line (no LF). With multiple CRs, all
FF (0Ch) Form Feed
DEL (07h)
SO (0Eh)
SI (0Fh)
DC2 (12h)
DC4 (14h)
CAN (18h)
ESC SO
ESC SI
ESC DC2
ESC DC4
ESC @
ESC ! n
ESC - n
PK80 Series 80-Column Printer User's Manual
The following control sequences are for the PK80F Printer:
Note: Any time ESC is used in a command, the command needs to con-
tain the actual ASCII character for ESC (0x1B), not the letters E-S-C.
There should be no spaces before the next character. Sometimes a space is
included in the documentation for readability.
Description
A single LF prints, advances paper, and places a carriage return at the end of the line.
Multiple LFs continues to advance paper (or insert blank lines).
CRs after the first are ignored.
S CR = print and position carriage at the end of line (no LF).
S LF = print, advance one line, and place carriage at end of line.
S CRLF = print and advance one line.
S LFCR = print and advance one line.
S CRCRCRCR. . .(n times) = print, place carriage at the EOL (no LF).
S LFLFLFLF. . .(n times) = print and advance n lines.
This prints, advances paper to the top of the next page, and places a carriage return at
the end of the line.
This cancels the previous character sent on that line.
This sets the double wide mode (if not in the condensed mode) for one line only and
cancels the condensed mode (if in the condensed mode).
This sets the condensed mode (if not in the double wide mode) and cancels the double
wide mode (if in the double wide mode).
This sets the pica pitch mode and cancels the double wide, emphasized, and condensed
modes.
This cancels the double wide mode set by SO.
This cancels the current line without printing.
This selects the double wide mode for one line only.
This selects the condensed mode.
This cancels the condensed mode.
This cancels the double wide mode.
This is the master reset, which resets the printer to its default states.
Master select - each bit in n selects or deselects a feature:
S All zeros — Select PICA
S Bit 0 — Select ELITE
S Bit 2 — Select Condensed (compressed)
S Bit 3 — Select Emphasized (bold)
S Bit 5 — Double Width (expanded)
S Bit 6 — Italic
S Bit 7 — Underline
This enables or disables the underline mode. If n=1, then enable the underline mode. If
n=0, then disable the underline mode.
—
Appendix A Commands
53