Intermec EasyCoder 501 XP Installation Instructions Manual page 5

Chapter 2 Installation
EasyCoder 501 XP and
601 XP, cont.
4
• Put back the cover over the electronics compartment. Press
fi rmly to compress the leaf springs along the front and rear
edges of the electronics compartment.
• Connect the power cord.
• Now you have two new interface connectors on the printer's
rear plate in addition to the standard serial interface "uart1:"
and the standard parallel interface "centronics:". Connect
the interface cables and switch on the power.
• Enter the Setup Mode to set the proper baud rate, character
length, parity, number of stop bits, fl owcontrol, new line,
and buffer size parameters for the new serial ports "uart2:"
and "uart3:".
EasyCoder XP- & F-Series Double Serial Interface Board – Installation Instructions Ed. 2
Serial Interface
"uart3:"
Serial Interface
"uart1:"
Serial Interface
"uart2:"
Centronics Interface
"centronics:"