Cleaning The Cutter - Intermec EasyCoder 3400e User Manual

Cleaning the Cutter

It is important that you routinely clean the cutter to keep it in excellent working
condition. If you are cutting through adhesive-backed media, you should clean
the cutter after every 10,000 cuts. To see the number of cuts made, print out a
hardware configuration test label as described in your printer user's manual.
The information following "Labels Cut" indicates how many labels have been
cut since the cutter was installed. Use this number to determine when to clean
the cutter.
If you are not using adhesive-backed media, you should clean the cutter when
it no longer cuts precisely.
Warning
Use extreme caution when cleaning the cutter to avoid cutting yourself.
Avertissement
Lors du nettoyage de la barre coupante, prenez bien soin de ne pas vous
couper.
To clean the cutter blade and paper guide
1. Turn off the printer.
2. Unplug the printer power supply cord and the cutter cable.
3. Turn the head lift lever clockwise and back the media out of the cutter.
4. Using a straight-slot screwdriver, loosen the screw on the top of the cutter
and swing the cutter cover down.
Cleaning the Cutter
44XXU.005
Cutter
cover
9