Lincoln Electric 180i MP Operator's Manual page 7

MULTIPROCESS WIRE FEEDER WELDER
GENERAL DESCRIPTION
This multi-process welding machine is intended for light
fabrication, maintenance, home and auto-body shops. The unit is
housed in a portable and rugged case, and features an intuitive
user interface with a push button for selecting processes and two
knobs for adjusting welding parameters. The machine also
features a cast aluminum wire drive system for reliable wire
feeding and an integrated switch for activating a Magnum
100SG spool gun. The multi-process machine is designed to be
connected to 120 or 230VAC single phase 60 Hz power.
This machine is capable of MIG, FCAW, TIG, and STICK welding.
The machine can support 4-inch and 8-inch spools of wire for MIG
and FCAW welding. The machine is intended for the following wire
diameters and composition; SuperArc
solid steel, self-shielded NR
®
Outershield 71M .035" FCAW-GS. Welding aluminum ER4043
®
.035" requires use of the Magnum
integrated spool gun switch is pre-installed from the factory and
located above the wire drive. The machine also permits TIG
welding with .040, 1/16" and 3/32" tungsten and STICK welding
with up to 1/8" electrode.
1
®
L-56 .025" through .035"
® ®
-211MP .030", .035", and .045" and
100SG Spool Gun. An
®
6
5
INCLUDED ACCESSORIES
1 Magnum 100L gun
®
2 Work cable with clamp
3 Spare contact tips
4 Gas regulator* and gas hose
5 Gas and gasless nozzle
6 Electrode holder and cable
7
Quick Start guide and literature
* The gas regulator knob is located in the wire drive compartment and must
be assembled to the regulator.
2
3
3
DESCRIPTION
4
7