Other Programming - Panasonic KX-TGE820E Operating Instructions Manual

Turning off the baby monitor
The monitored handset cannot be used while
baby monitor is set to "On".
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "Off" a MOKN a M
Editing an outside monitoring number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "On" a MOKN
4
MbN: Select the outside line.
5
MMENUN a MbN: "Edit" a MOKN
6
Edit the name if necessary. a MOKN
7
Edit the phone number if necessary. a
MOKN 2 times
Erasing an outside monitoring
number
1
Press MMENUN on the handset being
monitored.
2
MbN: "On/Off" a MOKN
3
MbN: "On" a MOKN
4
MbN: Select the outside line.
5
MMENUN a MbN: "Erase" a MOKN
6
MbN: "Yes" a MOKN a M
Baby monitor sensitivity
You can adjust the sensitivity of the baby
monitor. Increase or decrease the sensitivity to
adjust the sound level needed to trigger the
baby monitor feature.
R This feature cannot be set during a
monitoring call.
1
Press MMENUN on the handset being
monitored.
2
MbN: "Sensitivity Level" a MOKN
3
MbN: Select the desired setting. a MOKN
a M N
Helpline Tel. No.: U.K. 0344 844 3899 Ireland 01289 8333
Answering the baby monitor
n When monitoring with a handset:
Press M
If you want to respond from the monitoring
handset, press MMUTEN.
R The monitoring handset will answer calls
automatically when the auto intercom
N
feature is set to "On" (page 21).
Note:
R If you receive an outside call when
communicating with the monitored
handset, the interrupt tone sounds. To
answer the call, press M
M N.
n When monitoring from an outside line:
Answer the call.
If you want to respond from your monitoring
phone, press #1 using tone dialling.
You can turn off the baby monitor feature
by pressing #0.
Note:
R The unit disconnects the call
automatically after 2 minutes.

Other programming

Changing the handset name
The default handset name is "Handset 1" to
"Handset 3". You can customise the name
of each handset ("Bob", "Kitchen", etc.). This is
N
useful when you make intercom calls between
handsets. To display the handset name in
standby mode, turn on the handset name
display feature (page 40).
1
MMENUN#104
2
Enter the desired name (10 characters
max.).
3
MOKN a M
Programming
N to answer calls.
N, then press
N
39