Yamaha FX Nytro FX10A Owner's Manual page 79

4. Align the drive track by turning the left
and right adjusting nuts.
Drive track Shifted to
alignment
Left adjusting
Turn out
nut
Right adjust-
ing nut
1. Left adjusting nut
2. Right adjusting nut
Shifted to right
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
Periodic maintenance and adjustment
Shifted to left
right
Turn in
Turn in Turn out
Shifted to left
1. Forward
2. Gap
3. Slide runner
4. Drive track
5. Slide metal
5. Adjust the drive track deflection to speci-
fication. NOTICE: The right and left ad-
justing nuts should be turned an equal
amount.
[ECS00592]
Drive track More than
deflection specified
Left adjusting
nut
Right adjust-
ing nut
6. Recheck alignment and deflection. If nec-
essary, repeat steps 3 to 5 until the prop-
er adjustment is achieved.
7. Lower the snowmobile to the ground.
8. Tighten the rear axle nut.
Rear axle nut tightening torque:
75 Nm (7.5 m·kgf, 54 ft·lbf)
Slide runners
Check the slide runners for wear and dam-
age.
If the slide runners reach the wear limit, they
should be replaced.
Less than
specified
Turn in Turn out
Turn in Turn out
73