Weslo Cadence 55 User Manual page 7

3. With the help of a second person, raise the Handrails
(6, 7) so the Base (71) is flat on the floor as shown.
Attach the Wheels (15) to the outer sides of the Base
(71) with two Wheel Bolts (14) and two Nuts (17) as
shown (only one of each is shown). Do not overtighten
the Nuts; the Wheels should turn freely.
Position the front of the treadmill Frame (55) between the
Handrails (6, 7) as shown. Next, locate the long wire in-
side of the lower end of the Right Handrail (see the inset
drawing). Secure the end of the wire to the end of the
Wire Harness (22). Then, pull the other end of the long
wire until the end of the Wire Harness is extending from
the upper end of the Right Handrail.
4. Have a second person lift and hold the front end of the
Frame (55). Hold a Frame Spacer (13) between the Right
Handrail (6) and the Frame. Attach the Right Handrail to
the Frame with a Frame Bolt (10), a Handrail Washer
(30), and a Handrail Star Washer (60).
Repeat this step on the left side of the treadmill.
5. Hold the Console (1) near the Right Handrail (6). Touch
the Right Handrail to discharge any static.
Remove the wire from the end of the Wire Harness (22).
Insert the end of the Wire Harness through the three
looped plastic ties. Next, press the connector on the end
of the Wire Harness into the connector on the back of the
Console (1) in the location shown. See the inset draw-
ing. The connectors should slide together easily and
snap into place. If they do not, turn the connector and
then try again. IF THE CONNECTORS ARE NOT CON-
NECTED PROPERLY, THE CONSOLE MAY BE DAM-
AGED WHEN THE POWER IS TURNED ON.
3
7
55
4
5
7
6
17
22
71
Long
Wire
22
6
13
30
60
55
Connectors
1
Plastic
Ties
6
Connectors
22
15
14
6
10
22